Steakhouse.lu Steakhouse.lu

Technique

Tools:
fewer than you think.

A good steak needs three things: a pan that holds heat, a thermometer and a knife that cuts rather than tears. Everything else is pleasant but not necessary. What is good for what — and where most steaks actually go wrong.

Pan

Mass beats brand

What counts is how much heat the material stores. A heavy piece of cast iron beats any thin designer pan, whatever it cost.

Heat

A low ceiling

A domestic hob rarely delivers more than 250 °C at the pan. That is enough for a crust if the meat is dry and you don't crowd it.

Thermometer

The key piece

It replaces experience, the thumb test and luck. Ten seconds to read, two degrees of accuracy — nobody needs more, and it costs less than a steak.


The pan

Here is what happens when you sear: the cold meat pulls heat out of the pan all at once. How far the temperature drops decides the crust. A thin pan falls from 230 to 140 °C, and the steak starts boiling instead of roasting. A heavy pan may only fall to 190 °C and keeps browning.

MaterialStrengthsWeaknesses
Cast ironstores a lot of heat, indestructible, goes very hotheavy, slow to heat, needs care
Carbon steellike cast iron but lighter and quickerwarps if treated roughly
Thick-based stainlessdishwasher safe, excellent for pan saucesmeat sticks at first, technique required
Non-sticknever sticksunsuitable for steak: the coating cannot take the heat required

Size matters more than people think. Two steaks in a 24-centimetre pan sit too close; the escaping steam has nowhere to go and stops the browning. Better to sear one after the other, or use a pan with a hand's width between the pieces.

The heat source

  • Induction: fast and precisely controlled, but the field only heats the base. With a heavy pan that is plenty; the rim stays cooler, which actually helps when finishing.
  • Gas: the flame wraps round the sides and the heat can be cut instantly. In practice the most comfortable option.
  • Charcoal: goes well beyond 300 °C and is the only source that gives smoke aroma. The coals need 25 to 30 minutes to burn through evenly — put the meat on earlier and you get soot, not smoke.
  • Gas grill: convenient, but no aroma. Worth it mainly if it has a side burner or an infrared burner for the crust.
  • Oven: too cool on its own for a crust, but ideal for bringing meat to temperature in a controlled way, before or after searing.

The thermometer

The commonest mistake is not the wrong pan, it is guessing. Between medium rare and medium lie five degrees of core temperature and roughly 45 seconds — that cannot be felt, only measured.

  • Probe thermometer with a thin tip and a reading time under ten seconds: the right choice for steaks. Thick probes tear a hole for the juices to escape through.
  • Wired or wireless core probe: useful for large pieces, roasts and reverse searing, where you want to watch for over an hour.
  • Infrared thermometer: reads the surface only. Handy for pan or grate temperature, useless for the inside of the meat.

Measure in the middle of the thickest part, entering from the side rather than the top — that way you reliably hit the core and not the already-hot outer zone.

The knife

A blunt knife crushes the fibres and squeezes out juice before the piece even reaches the plate. Two knives are enough: a 20-centimetre chef's knife for portioning and a long, narrow carving knife for large pieces, drawn through in one stroke instead of sawing.

More important than the brand is the sharpening. A steel only realigns the edge, it does not sharpen. Once a year every knife belongs on a stone or with a professional — in Luxembourg several butchers offer this on the side.

Reverse searing and sous-vide

Both methods invert the usual order: bring to core temperature slowly first, then sear hard and briefly.

Reverse searing needs nothing but an oven. The steak goes on a rack at 90 to 110 °C until the core is about 8 °C below the target — for a four-centimetre piece, 35 to 50 minutes. Then one minute a side in a fiercely hot pan. The result is evenly pink from edge to edge, and the surface is by then so dry that the crust forms in seconds.

Sous-vide does the same in a water bath at an exact temperature. The advantage is that nothing can overcook; the drawback is that the meat must be dried very thoroughly before searing, or no crust forms. For thin steaks it isn't worth the trouble; for thick pieces and for guests, it is.

Where steaks actually go wrong

Not on equipment, but almost always on one of four things: the meat was cut too thin. It was wet when it hit the pan. There were too many pieces in at once. Or it was cut immediately instead of resting five minutes. Fixing all four costs nothing.

What you can skip

  • Steak tongs with a thermometer in the handle — they read the surface, not the core.
  • Twelve-piece barbecue tool sets — you use the tongs and nothing else.
  • Meat mallet for steaks — it destroys the structure you just paid for.
  • Marinades for good beef — oil, salt after searing, pepper at the end. Acidic marinades belong on tough cuts, not on a rib eye.
  • Ridged cast-iron grill pan — it makes pretty stripes and simultaneously stops the rest of the surface from browning.

Read next

Which temperature for what?

The full table of core temperatures for every level of doneness, plus the printable sheet for the kitchen wall.

See doneness levels